Kyocera FS-6030MFP

Maintenance mode
LE 04 MaintenanceLE 04 Maintenance
Maintenance
mode
Activity Enter the maintenance mode.
Recommendation • For setting the U-Parameter
• To print special reports (Eventlog)
• To print test charts for adjustments
• To adjust and calibrate the machine
•
To
adjust
and
calibrate
the
machine
Requirement • Knowledge of how to use the maintenance mode.
• Knowledge about the functions of the U-Parameter.
Tip The maintenance mode is not for user!
Starting the maintenance mode:
Take variant 2 if variant 1 doesn’t work.
For example if the accounting is active.
I i l lik
C
d
h t d l th f t ft
Variant 1: In copy mode Æ 1087 1087
Variant 2: Button Status/Print cancel Æ 1087 1087
I
n spec
i
a
l
cases
lik
e
C
-co
d
e you
h
ave
t
o open an
d
c
l
ose
th
e
f
ron
t
cover a
ft
er
entering 10871087.
Navigation in maintenance mode:
Entries: numeric keys or < > key
Confirm: START- or OK-key
Return: Return- or Stop- key
Quit the maintenance mode:
With the numeric keys by 001 and confirm with START key