Kyocera FS-6030MFP

Safety
Concept
LE 05 Command CenterLE 05 Command Center
LE 05 Command CenterLE 05 Command Center
Safety
Concept
Requirements Measure
The device's system settings
have to be protected.
The system settings are protected by a standard account (DeviceAdmin)
(FS-6025: 2500 / 2500 and FS-6030: 3000 / 3000
This standard account should be changed as required to ensure long-term
security.
security.
It is also practical to set up an additional account to ensure access if the
"official“ password is lost or unknown (should be arranged with the
customer).
In addition to system settings,
any unauthorized device
configuration
should generally be
prevented
See page Authentication
prevented
.
System settings must be
protected from access via the
Command Center.
Access to the Command Center is protected by a standard password
(admin00). This standard password should be changed as required to
ensure long-term security.
It is also practical to set up an additional account (see User Login) to
ensure access if the "official" password is lost or unknown.
Only selected communication
protocols must be used.
See page Network safety
Only certain interfaces must
be used.
See page Blocking the Interfaces
Only certain PCs must be allowed
to access the device.
See page IP-Filter
A
ccess to the device / Command
Center must only be
granted to certain persons.
Local Authentication
Specific use of the device is
granted to certain persons.
Local authentication linked to a cost center.