Kyocera FS-920 - Page 51

2GL/2FV/2FW
1-5-9
6010
(E4)
Fuser low temperature
• After the fuser heater lamp is turned
on, the temperature at the upper fuser
roller lower than 100
°C/212 °F contin-
ues for 30 s.
Defective the fuser
thermistor.
Follow the flow chart.
Defective the
engine/high volt-
age PWB.
Code Contents
Remarks
Causes Check procedures/corrective measures
No
Start
Yes
Replace engine/high
voltage PWB.
See page 1-6-17.
Replace the engine/high
voltage PWB.
See page 1-6-17.
Check the installation
condition of the fuser
thermistor. See page 1-
6-11.
Remedy or replace the
fuser thermistor.
OK?
No
Yes
End.
Turn power switch off,
then on.
"6010" error
shown?