Kyocera FS-920 - Fuser Unit

2GL/2FV/2FW
1-6-9
1-6-5 Fuser unit
(1) Detaching and refitting the fuser unit
<Procedure>
1. Remove the outer covers. See page 1-6-2.
2. Remove the two connectors.
3. Remove the wire from two clamps.
Figure 1-6-12
4. Pull out the rear cover axis (with spring)
from the axis hole () on side.
5. Pull out the rear cover axis from the axis
hole () on side and remove the rear cover
and the spring.
Figure 1-6-13
Connector
Clamp
Clamp
Wire
Connector
Spring
Spring
Rear cover
Axis
Axis hole
Axis
Axis hole

