Figure 1. Jumper Terminal (Normal Position)
4. Remove and fit the jumper so that the pins of terminal SW2 are short-circuited.
Figure 2. Resetting Position
5. Install the IB-23 in the printer.
6. Power up the printer.
7. Turn printer power off.
8. Remove the IB-23 from the printer.
9. Remove the jumper from SW2 and reset it to the normal position as shown in
Figure 1
above.
10. Insert the IB-23 in the printer.
The above procedure reinitializes all of the IB-23 settings.
Top of page
4/4 ページTroubleshooting
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\troubleshoot....
To Next Page
Loading...
