EasyManua.ls Logo

Kyocera FS-C5025N - IP Address Configuration

Kyocera FS-C5025N
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP Address Configuration
This section describes several methods for configuring the IP address information for the IB-23.
The method you use will depend on your particular network configuration as well as your personal preferences. For
example, if your network includes a DHCP server, then you will likely use DHCP for setting the IB-23 IP addresses.
Following are the possible methods for configuring the IP addresses:
Using DHCP
Using WINS
Using Quick Setup
Using RARP or BOOTP
Using ARP
Using the Printer's Operator Panel
A
fter following the procedures in this section to configure the IP address, it is recommended to verify the IP address
settings:
Verifying the IP Address Settings
Using DHCP
DHCP (Dynamic Host Configuration Protocol) provides a mechanism for delivering IP configuration parameters, including
IP address, subnet mask, etc. to devices on an IP network. DHCP alleviates the administrative burden of managing
individual IP addresses.
A
DHCP server processes IB-23 DHCP discovery broadcasts and returns an IP address to the IB-23. The DHCP server
may be set up to grant an IP address for a limited time (a temporary lease) or for an unlimited (an unlimited lease), or it
may be configured with a permanent address reservation for the IB-23.
! Note:
In a non-WINS environment (See
WINS Configuration,
below.), it is highly recommended to set up the DHCP
server to grant the IB-23 an unlimited lease or permanent address reservation.
Unlimited Lease or Address Reservation in Windows NT 4.0 and Windows 2000
In Windows NT 4.0 and 2000, lease duration is set for a particular scope, or group of addresses. Thus, lease duration
should be set to Unlimited for the scope to which the IB-23 belongs. If this is not desired, then the IB-23 should be defined
as a
Reserved Client
.
Use the following procedure in Windows DHCP Manager to add a reserved client.
1. Select the scope that the IB-23 will belong to, then select
Add Reservations
from the
Scope
menu. The
Add
Reserved Clients
window will open.
Fi
g
ure 1. Addin
g
a Reserved Client
1/9 ページIP Address Configuration
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\html\English\tcpip_setting.h...

Other manuals for Kyocera FS-C5025N

Related product manuals