End of Job
String
field. To access the End of Job String in the browser:
1. Connect to the IB-23 home page, e.g. http://192.168.40.17
2. Select
Printer Control
and enter the following command in the
End of Job String
: \x04
Resetting to Factory Defaults
How can I reset all IB-23 settings back to their factory default values?
With a browser:
1. Access the IB-23 webpage.
2. On the
Basic
tab, click
Reset
. Click
Set All Network settings to Factory Default
.
With the jumper arrangement:
If you are unable to communicate with the IB-23, it may be reset to factory defaults by changing the onboard jumper
arrangement. Proceed as follows:
1. Turn printer power off.
2. Remove the IB-23 from the printer.
3. Locate the jumper terminals on the board. Note the normal position of the jumper in reference to the terminals.
3/4 ページTroubleshooting
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\troubleshoot....
To Next Page
Loading...
