Figure 6. Quick Setup Confirmation Screen
Using RARP or BOOTP
You can resolve the IP address via RARP or BOOTP over the Ethernet connection. The host computer must support
either protocol as the boot server. The address information will be stored in a configuration file on the server as, for
example, ethers or bootptab file. The interface card issues each time the IB-23 is turned on RARP and BOOTP requests
and attempt to receive the configuration information returned by the server.
To prepare a configuration file for BOOTP
:
1. Properly connect the IB-23 to the network.
2. Create and store the configuration information in a
/etc/bootptab
file.
For example, to set '192.168.1.2' for IP address; the hardware address is '00:c0:ee:14:00:87,' enter as follows:
ht=ether:\ #Target hardware type
ha=00c0ee140087:\ #Target hardware address
ip=192.168.1.2:\
gw=192.168.1.1:\ #Default gateway address
sm=255.255.255.0:\ #Subnet mask
3. In
/etc/inetd.conf
, add:
bootps dgram, udp wait root /etc/bootpd bootpd
4. Reset inetd by:
kill -1 1
5. Turn IB-23 power off, then on.
6/9 ページIP Address Configuration
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\tcpip_setting.h...
To Next Page
Loading...
