Kyocera FS-C5025N - Page 15

Using the Printer's Operator Panel
You can directly enter the IP address, gateway address, and subnet mask address using the menu system from the
operator panel. The following procedure is applicable to virtually all Kyocera Mita printers except those having no operator
panel. For digital copier operator panel setting instructions, refer to the operation manual.
To set the IP address information, proceed as follows:
1. Press
MENU
(
MODE
).
2. Press the
^
(
+
) key until the printer displays:
If the above does not show 'Option,' press
ENTER
. Press the
^
(
+
) key repeatedly until it shows
Option
. Then, press
ENTER
again.
3. Press the
>
key.
4. Press the
^
(
+
) key until the printer displays:
5. Press the
>
key.
6. Press the
^
(
+
) key until the printer displays:
7. To enter the IP address, press
ENTER
. A cursor (_) begins to blink at the rightmost 3-digit segment. Use the
^
(
+
)
key to increase and the
v
(
-
) key to decrease the figure. When the rightmost segment is done, use the
<
key to
move the cursor to the next segment. Again, use the
^
(
+
) key to increase and the
v
(
-
) key to decrease the figure
for the segment. Repeat this procedure for all the segments. When all segments are done, press
ENTER
.
8. Press the
^
(
+
) key. The printer will display:
Using the same manner as 7. above, complete the gateway address. Press
ENTER
.
9. Press the
^
(
+
) key. The printer will display:
Using the same manner as 7. above, complete the subnet mask address. Press
ENTER
.
10. Press
MENU
(
MODE
). Turn the printer off and on. IP address configuration is complete.
Verifying the IP Address Settings
Print a network status page to verify that the IP address information has been properly set.
The network status page will also be useful during diagnostics on network problems.
Interface >
Option
>TCP/IP
>
On
>>IP Address
000.000.000.000
>>Gateway
000.000.000.000
>>Subnet mask
000.000.000.000
8/9 ページIP Address Configuration
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\tcpip_setting.h...