Using the Operation Panel
2-29
3
If the current interface is other than Network, press [OK]. A
blinking question mark (?) appears.
4
Press or repeatedly until Network appears. Press [OK].
5
Press and then press or repeatedly until the display
shows >Network Status Page.
6
Press [OK]. A blinking question mark (?) appears.
7
Press or to select On.
8
Press [OK] again.
9
Press [Menu]. The display returns to Ready.
Interface
? Parallel
Interface
? Network
>Network Status
Page Off
>Network Status
Page ? Off
>Network Status
Page ? On
To Next Page
Loading...
