Kyocera FS-C8100DN - Resetting the Custom Paper Type; Setting the Duplex Path

Using the Operation Panel
2-61
2
Press  or  repeatedly until >>Paper Weight appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Press  or  to display the desired paper thickness. The display changes as shown below. For
details of the default setting for each paper type, refer to Paper Availability on page 1-2.
Light
Normal 1
Normal 2
Normal 3
Heavy 1
Heavy 2
Heavy 3
Extra Heavy
5
When the desired paper thickness is displayed, press [OK] and proceed to Setting the Duplex Path.
Setting the Duplex Path
You can set whether or not to enable duplex printing as follows. The default setting is Enable.
1
Display the custom paper type (refer to Creating Custom Paper Type on page 2-58) and press .
2
Press  or  repeatedly until >>Duplex path appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select Enable or Disable using  or . For details of the default setting for each paper type,
refer to Paper Availability on page 1-2.
5
Press [OK].
6
Press [Menu]. The display returns to Ready.
The custom paper type setting is completed.
Resetting the Custom Paper Type
1
Press [Menu].
2
Press  or  repeatedly until Paper Handling > appears.
3
Press .
>>Paper Weight
Normal 2
>>Paper Weight
? Normal 2
>>Duplex Path
Enable
>>Duplex Path
? Enable
Paper Handling >