Using the Operation Panel
2-42
Operating the Storage Device
The printer supports three types of storage devices; memory card, hard disk, and RAM disk. The
memory card and hard disk are installed into the dedicated slots of the printer. The RAM disk is an
allocated part of the printer’s memory. If the hard disk is installed in the printer, the e-MPS function
will be available. For details, refer to e-MPS on page 2-15.
The basic operations of each storage device are the same. This section explains the operation of
the memory card.
Using the CompactFlash (Memory) Card
The printer is equipped with a slot for a memory card. By inserting a memory card into the printer,
the following operations become available.
• Reading Font Data
• Reading Data
• Writing Data
• Deleting Data
• Formatting Memory card
• Printing a List of Data Names
For details about the handling of the memory card, refer to CompactFlash (Memory) Card on
page 3-10.
Reading Font Data
If a memory card with the font data is inserted into the slot when the printer is turned on, the fonts
are automatically read into the printer.
1
Press [Menu].
2
Press S or T repeatedly until Memory Card > appears.
3
Press X.
4
Press S or T repeatedly until >Read Fonts appears.
5
Press [OK]. A question mark (?) appears.
6
Press [OK]. Processing appears and the reading of data from
the memory card starts. When completed, Processing
disappears.
7
Press [Menu]. The display returns to Ready.
Memory Card >
>Read Fonts
>Read Fonts ?
>Read Fonts
Processing
To Next Page
Loading...
Need help?
General