Using the Operation Panel
2-68
3
Press .
4
Press or repeatedly until >Print HEX-DUMP appears.
5
Press [OK]. A question mark (?) appears.
6
Press [OK] again. The message Processing appears for a
second, followed by Waiting.
7
While the message display is indicating Waiting (for 30 seconds by default), send data to be
hex-dumped to the printer. The message display indicates Processing while the data is being
received.
You can cancel printing of any more dump data by pressing [GO] and then [Cancel].
8
Once all data has been received, the message Waiting will appear. Press [GO] to finish hex-dump
printing.
Printer Resetting
The procedure described below resets the printer’s temporary conditions, such as the current page
orientation, font, etc., set by commands to their default values. Downloaded fonts and macros are
deleted from the printer’s memory.
1
Press [Menu].
2
Press or repeatedly until Others > appears.
3
Press .
4
Press or repeatedly until >Restart Printer appears.
5
To reset the printer, press [OK]. A question mark (?) appears.
>Print HEX-DUMP
>Print HEX-DUMP?
Processing
Waiting
Others >
>Restart
Printer
>Restart
Printer ?
To Next Page
Loading...
Need help?
General