Kyocera KM-1530

11
3. Troubleshooting
Error code
(15 ppm copier)
—
—
E23
E25
E30
E40
—
Display message
(20 ppm copier )
No duplex from bypass
Not from bypass to finisher
Paper capacity exceeded.
Remve paper from Job sep.
PAPER CAPACITY EXCEEDED.
REMOVE PAPER FROM JOB SEP.
Paper capacity exceeded.
Remove paper from Inner.
PAPER CAPACITY EXCEEDED.
REMOVE PAPER FROM INNER TRAY.
—
This code is not in use.
Exceeded print quantity
limit.
Exceeded pre-registered
printing quantity.
Procedure
Duplex printing is not possible using the Multi-Bypass. Select the drawer for paper
feed.
1. If you want to switch to and print from a different drawer, press the Paper Select
key until the desired drawer is selected and then press the Enter key.
2. Otherwise, press the Printer key to switch to the printer mode. Three different
commands will be displayed. Use the M and N keys to move the arrow e until
it points to the desired command and then press the Enter key.
GO: Prints out on only one side of the paper.
CANCEL: Cancels the printing operation completely.
RESET: Resets the Printer Board. (Only printer functions will be reset.)
The finisher cannot be used when paper is fed from the Multi-Bypass.
1. If you want to switch to and print from a different drawer, press the Paper Select
key until the desired drawer is selected and then press the Enter key.
2. Press the Printer key to switch to the printer mode. Three different commands
will be displayed. Use the M and N keys to move the arrow e until it points to
the desired command and then press the Enter key.
GO: Has the paper ejected into the Inner tray.
CANCEL: Cancels the printing operation completely.
RESET: Resets the Printer Board. (Only printer functions will be reset.)
The amount of paper stacked in the optional Job Separator has exceeded the
acceptable capacity. Remove all paper from the Job Separator.
<15 ppm copier>
The amount of paper stacked in the Inner tray has exceeded the acceptable
capacity. Remove all paper from the Inner tray and then press the Start key to
continue printing.
*If you want to cancel the printing operation completely, press the Stop/Clear key.
<20 ppm copier>
The amount of paper stacked in the Inner tray has exceeded the acceptable
capacity. Remove all paper from the Inner tray and then press the Printer key to
switch to the printer mode. Next, select the “GO” command and then press the
Enter key to continue printing.
*If you want to cancel the printing operation completely, select the “CANCEL”
command and then press the Enter key.
Trouble has occurred within the printer. Contact your service representative or an
authorized service center.
The department code you entered does not match the registered one. Check the
department code that is registered in the printer driver.
The amount of printing accomplished has exceeded the acceptable capacity as set
under copy management. In order to print further, change the copy management
setting in the printer.