Kyocera KM-3650W - Page 19

18
3.3.7.1 Cut Mode
“Standard Cut” enables the roll paper to be cut in a given standard size.
“Synchro Cut” enables the roll paper to be cut in an appropriate size to fit the image length.
Press the L1 Key repeatedly for either of them.
Press the Enter Key to apply the setting.
3.3.7.2 Paper Width/Media Setting
To specify the media width and type, press the R1 Key to enter Width/Media Setting.
For “Roll Deck 1”, press the L1 Key repeatedly for the media width, press R1 Key for media
type.
For “Roll Deck 2”, press the L2 Key repeatedly for the media width, press R2 Key for media
type.
For “Bypass Tray”, press the L3 Key repeatedly for the media width, press R3 Key the
media type.
The following Media Width settings can be specified for roll papers.
DIN: 36”, A0, A1, A2, A3
ENG: 36”, 34”, 22”, 17”, 11”
ARCH: 36”, 30”, 24”, 18”, 12”
The following Media Width settings for “Bypass Tray” are provided.
DIN: 36”, A0, A1, A2, A3
ENG: 36”, 34”, 22”, 17”, 11”, 8.5”
ARCH: 36”, 30”, 24”, 18”, 12”, 9”
The following Media Type settings are provided.
• Plain
• Vellum
• Film
Press the Enter Key to apply the setting.