25
4. Scan
4.1 Scan Mode Screen
The picture below is the basic Scan Mode Screen to make a scan.
Make sure that “Ready to Scan” is indicated in the upper left of the screen before scan.
Originals can be carried to the scanner only when Copy/Scan Mode Screen is displayed.
Make sure that “Ready to Multi Scan” is indicated in the upper left of the screen before
multi scan.
How to launch or cancel “Ready to Multi Scan” is described later.
After scanning the first page of the original, “Ready to Multi Scan” and “Press Enter to finish
scanning” are indicated by turns.
The number of the scan originals is indicated in upper right of the screen.
The other settings you should check before scan are as following.
• Original Size
• Quality
• Destination
• STF Format
• STF DPI
The above settings are described later.
To Next Page
Loading...
