20
Make sure of the following notes when Cut Mode is “Standard”
A copy length is always equal to an acquired standard size.
Adding and reducing a leading edge extends a part of the image out of the paper.
The excess part will be removed, and the range at which the image is placed originally will
be a blank.
3.3.7.6 Margin-Trailing edge
A margin can be provided to the training edge of a copy, or part of the image can be
deleted from a copy.
To specify the training edge, press the R2 Key or L2 Key to enter Advanced Settings (2).
Training edge adjustment covers from - 100 to + 100 millimeters in increments of 1
millimeter.
To provide a margin, input a positive value.
To delete the trailing image, input a negative value.
Press the R3 Key to increase the value, L3 Key to decrease.
Press the Enter Key to apply the setting.
<Notes>
When providing a margin, a given length of the margin is added to the bottom of the copy.
When deleting a leading image, a given length of the image can be reduced or enlarged
depending on the zoom setting.
To Next Page
Loading...
