2FB/2FC-2.0
1-4-56
U258
Switching copy operation at toner empty detection
Description
Selects if continuous copying is enabled after toner empty is detected, and sets the number of copies that can
be made after the detection.
Purpose
To change the copying operation after detection of toner empty status.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select single or continuous copying. The selected item is displayed in reverse.
Initial setting: SINGLE
2. Set the number of copies that can be made using the * or # keys.
The setting can be changed by 5 copies per step.
When set to 0, the number of copies is not limited regardless of the setting for single or continuous copy-
ing.
3. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
Press the stop/clear key at the screen for selecting an item.
The screen for selecting a maintenance item No. is displayed.
U260
Selecting the timing for copy counting
Description
Changes the copy count timing for the total counter and other counters.
Purpose
To be set according to user (copy service provider) request.
If a paper jam occurs frequently in the optional document finisher when the number of copies is counted at the
time of paper ejection, copies are provided without copy counts. The copy service provider cannot charge for
such copying. To prevent this, the copy timing should be made earlier.
If a paper jam occurs frequently in the paper conveying or fuser sections when the number of copies is
counted before the paper reaches those sections, copying is charged without a copy being made.
To prevent this, the copy timing should be made later.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select the copy count timing. The selected item is displayed in reverse.
Initial setting: EJECT
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
SINGLE MODE Enables only single copying.
CONTINUE MODE Enables single and continuous copying.
Description Setting range Default setting
Number of copies after toner empty detection 0 to 200 200
Display Description
FEED When secondary paper feed starts
EJECT When the paper is ejected
To Next Page
Loading...
