2PZ-3
1-5-39
(4) Detaching and refitting the high voltage PWB
Procedure
1. Remove the right rear cover and right
cover (see page 1-5-6).
2. Remove the screw.
3. Release four Hook A of the high voltage
PWB upside.
4. Slightly slant the PWB like opening the
PWB upside and pull out the FFC.
Figure 1-5-59
5. Slant the high voltage PWB 90 degrees
and then pull the high voltage PWB
rightward and remove it.
*: If trying to pull out the PWB on the way of
slanting till 90 degrees, the hooks B secur-
ing the PWB’s bottom may damage.
6. Check or replace the high voltage PWB
and refit all the removed parts.
Figure 1-5-60
(Notes when reconnected)
1. Check the high voltage PWB is surely
secured with eight hooks.
2. After reattached, check if the ground spring
can be seen from the two-hole of the 18
grounding sections.
Figure 1-5-61
Hole
Spring
High voltage PWB
To Next Page
Loading...
