2PZ-1
1-5-65
(Disconnect the connectors on the main PWB.)
[For the machine with FAX]
26. Remove two screws and then remove
the FAX control PWB.
[For the machine with the hard disk or the net-
work interface card
]
27. Remove two pins and then pull out the
hard disk or the network interface card.
Figure 1-5-104
28. Remove four screws and then remove
the power source shield.
*: Screws A and B are unidentical, Thus, do
not mix up.
Figure 1-5-105
Screw
FAX control PWB
Hard disk
Screw
Screw
Screw
(Machine with FAX)
(Machine with the hard disk or
the network interface card)
Power source shield
Screw B
Screw A
Screw A
To Next Page
Loading...
