2LK/2LN/2LM/2LC-2
1-3-96
U140 Setting: [Mag Duty]
1. Select the item to be set.
2. Change the setting value using the +/- keys or numeric keys.
*: 55 ppm model only.
3. Press the start key. The value is set.
Method: [AC Calib] (45 ppm model/55 ppm model)
1. Select the item.
Method: [Calibration]
1. Turns the items to implement to on.
2. If the machine is installed at high altitudes, turn all of CMYK to On.
Changing Type to 1 sets all of CMYK to On.
3. Select [Execute].
4. Press the start key. AC calibration is executed.
5. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
* : When an error occurs, an error code is displayed.
Setting: [Magnification]
1. Select the item to be set.
2. Change the setting value using the +/- keys or numeric keys.
3. Press the start key. The value is set.
Item No. Description
Display Description
Setting
range
Initial setting
30ppm 35ppm 45ppm 55ppm
Normal Developer magnet roller duty 0 to 99 37 37 68 68
B/W* Developer magnet roller duty in
black/white mode
0 to 99 - - - 68
Display Description
Calibration Executing the AC calibration
Magnification AC calibration target bias value setting
High Altitude Mode setting for AC calibration bias control
Display Description
C When replacing the developer unit C or drum unit C
M When replacing the developer unit M or drum unit M
Y When replacing the developer unit Y or drum unit Y
K When replacing the developer unit K or drum unit K
Type Setting the mode
Display Description
Setting
range
Initial
setting
C When replacing the developer unit C or drum unit C -10 to 15 15
M When replacing the developer unit M or drum unit M -10 to 15 15
Y When replacing the developer unit Y or drum unit Y -10 to 15 15
K When replacing the developer unit K or drum unit K -10 to1 5 12
To Next Page
Loading...
