2LK/2LN/2LM/2LC
1-3-159
U411 7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Method: [DP FaceDown (Chart1)]
To manually enter the target value
1. Enter the target values which are shown on the specified original (P/N: 7505000005) execut-
ing maintenance item U425. Set a specified original (P/N: 7505000005) on the DP face
down.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [U425] and press the start key.
5. Select [DP FaceDown (Chart1)].
6. Select [All].
To manually enter the target value
1. Set a specified original (P/N: 7505000005) on the DP face down.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [Auto] and press the start key.
5. Select [DP FaceDown (Chart1)].
6. Select [All].
7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Item No. Description
Display Description
All Executing the adjustment in the DP scanning section (second
side) for magnification, leading edge timing, center line, MTF
filter, input gamma and matrix
To Next Page
Loading...
