Notice to Users 3
Notice to Users
For U.S.A. only
For U.S.A. and Canada
After a suitable place has been selected for the installation of the equipment, please do not change it. Avoid excessive heat, dust,
vibration and direct sunlight. Also, provide proper ventilation as the copier emits a small amount of ozone.
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 and Part 18 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
WARNING
Changes or modification made to this equipment, not expressly approved, could void the user’s authority to operate the equipment.
User Safety
This Multifunctional Digital Systems does not produce laser radiation hazardous to the user. It is certified as a Class 1 laser product
under the U.S Department of Health and Human Services (DHHS) Radiation Performance Standard according to the Radiation
Control Health and Safety Act of 1968 including amendments.
Protective housing and external covers completely confine the laser beam light emitted inside the Multifunctional Digital Systems.
The laser beam cannot escape from the machine during any phase of user operation.
Regulations implemented on August 2, 1976 by the Bureau of Radiological Health (BRH) of the U.S Food and Drug Administration
apply to laser products manufactured from August 1,1976. Laser products marketed in the United States must comply with these
regulations.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
USE OF RECYCLED PAPER IN THE COPIER
As with all copiers and reproduction devices, the use of the appropriate paper ensures the best image quality of the copies and the
machine’s performance and reliability.
Because of the extreme variances in composition and quality of paper from various manufacturers, consumers should ensure the
recycled paper they use is suitable for the copier.
If you have any questions regarding the use of recycled paper in your copier, contact your authorized service technician.
Other Notices
This product contains a CR Coin Lithium Battery which contains Perchlorate Material - special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/
The high efficiency LCD backlights used in this product contains 5 mg or less of Mercury, the disposal of which may be regulated
due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic
Industries Alliance (www.eiae.org).
The unit is classified as Class 1 Laser Product according to IEC 60825-1:1993/EN 60825-1.1994 including amendments.
The unit uses laser diode of output 13.3 mW, wave length 788 nm, continuous pulse.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
To Next Page
Loading...
