Original instructions
T
T
A
A
B
B
L
L
E
E
O
O
F
F
C
C
O
O
N
N
T
T
E
E
N
N
T
T
S
S
CHAPTER 1: INTRODUCTION 1
CHAPTER 2: PREREQUISITES 2
Space Requirements 2
Clearance 2
Location Requirements 3
Exhaust Requirements 4
Electrical Requirements 4
Service Line Requirements 5
CHAPTER 3: GETTING STARTED 6
Unpacking the Biosafety Cabinet 7
Preparing the Biosafety Cabinet for Operation 7
Moving and Lifting the Biosafety Cabinet 8
Installing the Biosafety Cabinet on an Existing Work Surface 8
Installing the Biosafety Cabinet on a Labconco Base Stand 8
Telescoping Base Stands 9
Manual or Electric Hydraulic Lift Base Stands 9
SoLo Electric Hydraulic Lift Base Stands 9
Connecting the Biosafety Cabinet to Utility Service Lines 10
Optional Ventus
TM
Exhaust System Connections 11
Optional Vacu-Pass
TM
Cord and Cable Portal Use 12
Drain Valve Installation 13
Initial Certification 14
CHAPTER 4: PERFORMANCE FEATURES AND SAFETY
PRECAUTIONS 15
HEPA Filters 15-16
ULPA Filters 16
Laminar Airflow 17
Directional Airflow 18
Motor/Blower 19
Cabinet Air Intakes (Grilles), Ductwork & Air Balance Controls 20
Ultraviolet (UV) Lamp 20
Safety Precautions 21-22
CHAPTER 5: USING THE CABINET 23
To Next Page
Loading...
