Lamona LAM7002 - Setting Microwave and Combi Functions; Heat-Up Indicator and Fast Heat Up; Residual Heat

Setting the Combi function
1. Turn on a heating function. Refer to "Setting a heating function".
2. Press
and do the same steps as when you set the Microwave function.
For some functions the microwave will start as soon as the set temperature is
reached.
Functions not available for the Combi function: Favourites, End Time, Set + Go, Heat +
Hold.
Setting the Microwave Quick Start function
1. If necessary, press to turn off the oven.
2. Press to turn on the Quick Start function.
Each press of
adds 30 seconds to the Duration time.
You can change the microwave power (refer to "Setting the Microwave
function").
3. Press to set the time for the function: Duration. Refer to "Clock functions" chapter,
Setting the clock functions.
Heat-up indicator
When you turn on a heating function, the bar on the display comes on. The bar shows that
the temperature increases. When temperature is reached the buzzer sounds 3 times and
the bar flashes and then disappears.
Fast Heat Up
This function decreases the heat-up time.
Do not put food in the oven when the Fast heat up function works.
To turn on the function, hold for 3 seconds. The heat-up indicator alternates.
Residual heat
When you turn off the oven, the display shows the residual heat. You can use the heat to
keep the food warm.
17