Lancom DSL Series - Page 28

LANCOM Wireless DSL – LANCOM Wireless ADSL
 Chapter 2: Installation
28
EN
The WLAN link display can assume three states:
WLAN data
Gives information about the data traffic in the wireless LAN access.
The WLAN data display can assume three states:
VPN
Status of a VPN connection. Only active with LANCOM VPN Option installed.
Security
Status of the firewall. Indicates the status of the security settings and averted
attacks to the protected network.
off No wireless LAN adapter found
green constantly on Wireless LAN adapter ready for use
green flickering Activity in wireless LAN (blinking frequency indicates the
number of registered stations)
off No data traffic
green flickering Data traffic
green flashing Error in the wireless LAN (e.g. sending error because of bad
connection quality)
off No VPN tunnel established
green blinking Negotiating VPN connection
green flashing Establishing first connection
green inverse flashing Establishing further connection
green constantly on VPN connection established
green constantly on Security settings ok. Packet filter rules are set.
red/
green
blinking Insecure configuration
red flickering Security alert: data packet filtered by firewall rules