8
1.8
All vise types from LANG Technik (Makro•Grip
®
/ Makro•Grip
®
FS / Profilo / Avanti / Vario•Tec) use the same base
body in different lengths and widths. This ensures that all jaw types are fully compatible with each other. Suitable
jaw types can be added as required.
NOTE
All suitable components can be found in the catalog or on our website.
1.9
The 5-Axis Vise is supplied with four Quick•Point
®
clamping studs as standard. An exception is the Makro•Grip
®
(FS) micro 5-Axis Vise, which only has two clamping studs. This enables precise positioning in the Quick•Point
®
52
or 96 zero point clamping system, which is mounted on the machine table of the CNC machine tool.
INFO
Under certain circumstances, direct bolting to the machine table/pallet is possible.
Please contact support@lang-technik.de
1
To Next Page