Lanier LD225 - Saving Energy; Auto off

Turning On the Power
29
1
Saving Energy
-Energy Saver Mode
If you do not use the machine for a
certain period after an operation, or
when you press the {Energy Saver}
key, the display disappears and the
machine goes into Energy Saver
mode. When you press the {Energy
Saver} key again, the machine returns
to the ready condition. The machine
uses less electricity in Energy Saver
mode.
Note
❒ You can change the amount of time
the machine waits before switch-
ing to Energy Saver mode after
copying has finished or the last op-
eration is performed. See p.62
“Panel Off Timer”.
-Auto Off
The machine automatically turns it-
self off when the job is finished, after
a certain period of time has elapsed.
This function is called "Auto Off".
Note
❒ You can change the Auto Off time.
See p.62 “Auto Off Timer”.
❒ The Auto Off Timer function will
not operate in the following cases:
• When a warning message ap-
pears
• When the service call message
appears
• When paper is jammed
•When the cover is open
•When the "
Add Toner" message
appears
•
When toner is being replenished
•When the User Tools/Counter
screen is displayed
•
When fixed warm-up is in progress
• When the facsimile, printer, or
other functions are active
•
When operations were suspend-
ed
during printing
• When the handset is in use
•
When the On-hook dialing func-
tion
is in use
• When a recipient is being regis-
tered in the address list or
group dial list
• When the Data In indicator is on
or blinking
• When the screen of stored docu-
ment under the printer function
is displayed
RuC4_EN_gsg-F_FM_forPaper.book Page 29 Tuesday, April 5, 2005 12:06 PM