AppleTalk Configuration
7 - 2
7.2 Macintosh Services
Before attempting to print from a Macintosh, ensure that AppleTalk and PostScript are
both enabled on at least one service. Once the service is conÞgured, it will appear in the
Chooser in the same zone as the MPS. Select the service in the Chooser and complete the
appropriate setup options. Then close the Chooser window and print a test page of text
to the Macintosh service.
7.3 AppleTalk Zones
If there is a router on the network, the MPS will appear in the default zone speciÞed by
the router. To change the default zone use the DeÞne Protocol AppleTalk Zone
command.
If the MPS is attached to a network without an AppleTalk router, all AppleTalk devices
(including the MPS) will appear in the default zone in the Chooser.
NOTE: If no router is present on the network, the MPS will not accept AppleTalk
print jobs for 60 seconds after booting.
To Next Page
Loading...
Need help?
General
