Troubleshooting
B - 1
B - Troubleshooting
B.1 Power-Up Troubleshooting
There are several possible error situations if the LEDs do not ßash.
Table B-1: Error Messages
Message Diagnosis/Remedy
Power-up diagnostic failure (hardware
failure)
Note which LED is blinking and its color, then contact
your dealer or Lantronix Technical Support.
The Server boots but does not try to
load the Flash ROM code
Press the Test button. A brief description of the problem
will be queued to the parallel port and printed.
Network Error: The ACT LED will blink
yellow 2-3 times per second
A. Make sure the Ethernet network cable is properly
connected and reboot the server.
B. If option A fails to resolve the problem, reload Flash
ROM. See Appendix D.
To Next Page
Loading...
