50 51
increment.
Should the battery voltage show low capacity, the sequence will be followed by an
additional 5 short beeps.
Note: At the same time the output volume setting is automatically changed to
low volume “1” and it cannot be changed until the batteries have been replaced.
12.2 Setting Warnings
The setting of warning altitudes can be performed either on the ground or in the
airplane during climb to jump altitude.
For settings, please read “Warning Windows (common for all)”.
13 - High Speed Warnings
NOTE: Factory preset values for High Speed Warnings:
--- ft., 4500 ft., 3000 ft., 1500 ft.
The window shows:
· Warning1
· Warning2
· Warning3
· Warning4
· Active Memory Bank
To Next Page
Loading...
