86 87
18.4 Dive Type
The Dive Type mode can be used to change the parameters when the PROTRACK II
detects freefall exit and canopy deployment.
Press
again and Dive Type flashes.
Press or to select Dive Type.
Changing Dive Type from ”----“ (Normal) to any other mode will change the PROTRACK
II sensitivity.
18.4.1 Dive Type, 3-SEC
In 3-SEC mode the descent rate parameters are more sensitive, allowing detection of
short freefalls (around 3 sec. freefall) for logbook exit altitude generation.
See note 1 and 2.
18.4.2 Dive Type, SLO (Slow)
In SLO mode the deployment calculation parameters are more sensitive.
Supports slow falling types of dives, like normal wing suits dives etc.
See note 1 and 2.
18.4.3 Dive Type, S-SLO (Super Slow)
In S-SLO the exit and deployment calculation parameters are more sensitive.
This mode is for very slow wing suit dives, fast canopy descents, Extreme Relative
Work (XRW) etc.
All high speed warnings are enabled regardless of the vertical airspeed at the preset altitudes.
To Next Page
Loading...
Need help?
General
