21
follows. Under STOP condition AUTO FOCUS and all other function keys can be
operated while NEXT FILE and DELETE keys are invalid under Single file mode.
! Multiple File Mode:
Turn on power, LaserPro is under STOP condition and all function keys can be
operated. Laser engraver is ready to receive a file. LCD shows as follows.
Upon the receipt of a complete file, LCD will show the following message for
instance. Then press START/STOP key, the engraver start engraving or cutting.
If there is no file having been sent, the message will display as follows.
NOTE:
Please refer to the flow chart of “Start to Operate”, page 14 .
ENTER
Accept and store the selection for setting up.
AUTO FOCUS
This key can only be operated under STOP condition. Press this key will move up
the working table until the engraving object touches the tip of the focus tool, then
the table will move down and stop in focus automatically.
Whenever you change a lens with different focal length, press Function key and go
File: file name
Speed: % 00:00
Power: % STOP
DPI:
File:
Speed: % 00:00
Power: % STOP
DPI:
File: # 1 file name
Speed: 70 % 00:00
Power: 40 % STOP
DPI: 500
Wait until at least one
complete file is
Received, then press START
to start a
To Next Page
Loading...