23
ESC (Escape)
Exit and back to the main menu.
NEXT FILE
This key is valid under Multiple file mode only. Press this key the LCD shows
The “k” message shows on the lower right corner expresses the k bytes memory that
has been left over in the buffer.
File: # shows the current working file number. Press NEXT FILE each time will
increase 1 (i.e. 1, 2, 3…100) and recycle the counting. Once the buffer has received
up to 100 files, the LCD shows:
If a file received is out of memory, the LCD shows
RED BEAM
On/Off red beam
SPEED
Set up laser speed for desired effect. When working without using VENUS’s driver.
Press FUNCTION key then select one of the sixteen setups then set up desired
cutting speed. No matter you are using VENUS’s driver or not, you can press
PAUSE key prior to change speed during cutting or engraving. Set up desired speed,
press ENTER then press RESUME to start the job again.
POWER
Set up laser power for desired depth and effect. Other conditions are same as stated
in SPEED.
File: # x file name
Speed: xx % 00:00
Power: xx % PPI: xxxx
DPI: xxx xxxxx k
More than 100 files
are not allowed
Please delete some
and send again
Not a complete file
due to out of memory
Please delete some
and send again
To Next Page
Loading...