25
FUNCTION
! Set memory buffer?
Setting memory buffer in Single file mode when working with a large data file, or
Multiple file mode (up to 100 files) that can be saved for constant engraving.
Under Single file mode, you can only output one job a time. Unlimited data can be
transferred without saving in the buffer therefore once you want to repeat the job
you have to re-send the file from the host computer.
Under Multiple file mode, you can engrave one job while transfer and design the
next simultaneously until 100 files’ memories are all used up.
Press FUNCTION key
Single /1File
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
Set memory buffer?
Yes: ENTER
End operation: Esc
Z init/AF position? :
Press ENTER key
Multiple /100 Files **
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
Z init/AF position?
Yes: ENTER
End operation: Esc
Delete all files ?:
ENTER
△
△△
△ or ▽
▽▽
▽
To Next Page
Loading...