26
! Z init/AF position?
To avoid focus carriage hitting the engraving object accidentally during initializing,
working table will move down about 50mm automatically after power on the
equipment. Whereas, if a rotary attachment has been installed, the working table will
move down to the bottom of the engraver.
As long as you have not press AUTO FOCUS key, you can go into this function and
move the working table back to the original position before initializing. Once the
AUTO FOCUS key has been used, the last auto focus position has been saved in the
memory. Therefore, you can move the table to the last auto focus position instead of
the original Z position by using this function.
Z init/AF position?
Yes: ENTER
End operation: Esc
Delete all files? :
Table is moving to
init or AF position
End operation: Esc
Delete all files? :
Delete all files?
Ok: ENTER
End operation: Esc
Select lens? :
ENTER
To Next Page
Loading...