LaserPro Venus - Page 29

29
! Set power ramp?
If set in Enable condition and cutting speed is 3% or above, under vector mode, the
power control is enabled. If set in Disable, the power control is disabled.
Default : Enable
Select unit?
Yes: ENTER
End operation: ESC
Set EOF alarm? :
Set power ramp?
Yes: ENTER
End operation: ESC
Select unit? :
ENTER
Enable **
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
Change: △
△△
△ or ▽
▽▽
▽
Disable
Ok: ENTER
Change: △
△△
△ or ▽
▽▽
▽
ENTER