Preparations
15.05.01
YAEE0013
15
Operation with cooling coil
(➾ Section 10.
Accessories)
− Pull the clamping bracket to the back for fixing the
cooling coil while releasing it with a screwdriver.
− Push the cooling coil on the clamping bracket.
− Install the clamping bracket again.
Operation with fixing rod
(➾ Section 10. Accessories)
− Pull the clamping bracket to the back while releasing it
with a screwdriver.
− Install the fixing rod together with the clamping bracket.
Operation with external circuit
(➾ Section 5.4.)
− The immersion thermostats have to be fixed carefully at the bath, for they must
not fall into the bath.
− In that case don’t touch the bath liquid! Pull out mains plug immediately!
a) Bath/Circulation thermostats
− Place the unit on a flat surface.
☞
− Do not cover the ventilation openings at the
back.
− Keep a clear distance of at least 20 cm.
− Put the control unit with the bath bridge on
the bath
− When operating without an external
consumer (bath thermostat) the setting
knob has to be turned so that the flow
comes out of the outlet for bath circulation
(➾ ill. 3, Section 5.1.).
To Next Page
Loading...
