Lauda Ecoline E 215 T - Setting the Baud Rate; Transfer Rate (Serial Interface)

Starting up
30
− The display shows the current bath temperature, ADR
and the current unit address (e.g.. 15).
Press the key, display flashes (approx. 4 s.).
or
− During this time start to set the required unit address.
(possible setting: 000...127)
− Forward with key to ”Setting the baud rate” or
− back with key to ”Selection of the interface” resp. when
pressing the key twice you return to ”Setting the reset
time...”“
6.4.3.4 Setting the Baud rate/ transfer rate (serial interface)
and 2x
− Directly from level 0 (setpoint selection), press the key
combination on the left, until the PARA function is
reached, then
and 3x
− switch to level 2 and move forward with key on the left.
− The display shows the current bath temperature, KBD
and the current setting. To alter the setting press the key.
− Display flashes (approx. 4 s).
or
− During this time, start to set the required value with one of
the two keys.
Settings available: 2400, 4800, 9600 or 19200 baud
− Forward with key to "user calibration" or