Lauda Ecoline E 215 T - Menu Functions; Pump Output

Starting up
15.05.01
YAEE0013
25
6.4 Menu functions
− Switching from setpoint selection (level 0) to level 1 using
the key
or
− Within one level it is possible to scroll using the keys.
− In principle, after each setting has been made it is entered
automatically after approx. 4 s or
− Settings are entered immediately on operating this key
6.4.1 Pump output
− For setting the pump output starting from level 0, press the
key shown on the left.
− The display shows the current bath temperature, PUMP and
the current output step. To alter the setting press the key
shown on the left.
− Display flashes (approx. 4 s).
or
− During this time start to set the required step with one of the
keys.
0 = pump stopped, heating off
1 = low pump output
2 , 3 , 4 = medium pump output
5 = maximum pump output
− The pump responds immediately (can be heard). (Setting is
entered after approx. 4 s ➾ Section 6.4.)
− Move forward with key to "Selecting the setpoint resolution"
or
− back with the key to "Setpoint selection".