Lauda Ecoline E 215 T - Setting the Reset Time of the PID-Controller

Starting up
28
− The display shows the current bath temperature Xp
and the current setting. To alter the setting press the
key on the left. Available settings from 0,5 to 9,9 °C .
(➾ Section 6.4.3.2.
☞
Note).
(➾ Section 9. Technical data)
− Display flashes (approx. ca. 4 s).
or
− During this time start to set the required value with one
of the two keys.
− Forward with the key to "Setting the reset time" or
− with the key back to "PARA".
6.4.3.2 Setting the reset time of the PID-controller
and 2x
− Directly from level 0 (setpoint selection), press the key
combination on the left (top one on E 3xx, bottom one
E 2xx), until the PARA function is reached, then
and 1x
− switch to level 2 and move forward with the keys on the
left.
− The display shows the current bath temperature, Tn and
the current setting. To alter the setting, press the key on
the left.
!
Possible adjustment from 5 to 60 s
− The display is flashing (approx. 4 s).