Preparations
15.05.01
YAEE0013
17
Emptying
− Switch off the thermostat, pull out the mains plug!
a) Immersion thermostat, Bath/ Circulation thermostat
− Unscrew the immersion thermostat or take off the control
unit with the bath bridge.
− Drain the bath.
☞
− The units are designed for operation with non-flammable and flammable liquids to EN
61010-2-010! Flammable liquids can be operated up to no more than 25°C below the
firepoint (➾ Section 5.3.).
− Observe the appropriate regulation when disposing used thermostating liquid.
− When connecting an external consumer take care that the level of the bath liquid does
not drop too much ! fill in bath liquid if necessary.
Do not drain the thermostating liquid when it is hot or very cold (below 0°C)!
To Next Page
Loading...
