LAUNCH TECH X-431 PRO - About; Login;Exit from Current Account

LAUNCH X-431 PRO (DBSCar V) User Manual
79
Tap “Scan” to select the desired local Wi-Fi network from the list, and type in
the security password (If it is an open network, password is not required), and
then tap “Confirm”.
4. Once the Wi-Fi network of the printer is connected and the printer is found,
tap “Printing test” to test the printing.
Now you can use the Wi-Fi printer to print!
If the printer is not found, please reset the printer to default factory settings (refer
to Step 2 for details) and check whether the current device and the printer are on
the same LAN.
B. If you have configured the Wi-Fi printer to the LAN:
2. Tap “Connect to Printer”:
a). If the local network remains as it is, tap “Test Print” directly to test the
printing.
b). If the local network changes, you have to reset the Wi-Fi printer.
9.8.4 About
The software version information and disclaimer are included.
9.8.5 Login/Exit from current account
To logout the current user ID, tap “Exit from current account”.
To login the system again, tap “Login”.