LAUNCH X-631/X-631+ Wheel Aligner Operation Instructions
4-10
Fig.4.31
[Vehicle license plate number]: The license plate
number of the vehicle under test.
[Client information]: The corresponding information for
the owner of the vehicle under test, including [Client
name], [Contact], [Telephone] and [Address]. The client
information cannot be directly entered in this interface
with the keyboard. Icon
behind [Client name] must
be clicked to enter the interface of [Client Management],
and then the corresponding [Client information] can be
selected. If information of this client is not available in
[Client Management], it must be added first before
selection (Please refer to [Configuration] – [Client
management]).
[Vehicle information]: The corresponding information of
the vehicle under test, including [Mileage],
[Manufacturer], [Model], [Start year] and [End year].
The vehicle information cannot be directly entered in
this interface with the keyboard. If the vehicle model
has been selected in [Measurement] – [Select vehicle
model], the corresponding information of the vehicle
model selected will be displayed in this interface. If not,
no any information is displayed in this interface.
[Operator]: Name of the operator who is operating
the instrument now. The corresponding [Operator] can
be selected only after the [Operator] column of
[Information for service station] is added (Please refer
to [System management] – [User information]).
[Fault cause]: The symptoms of the vehicle under test.
There are 5 options: [Tire wear], [Pull], [Steering wheel
is not centered], [Steering wheel swings] and [Others].
[Save]: To save the alignment data of the vehicle under
test ([Vehicle plate number] and [Client name] must be
entered, and [Fault cause] must be selected first before
saving).
[Print]: To print the alignment data of the vehicle under
test in the format of form or image (Please refer to
[System management] – [Report setting] for the format
setting of the report form).
Caution: The report form print function provided by this
interface only aims at the individual information report
form for the test at this time; the report form print
function provided by the main interface aims at all the
information report forms saved and done before.
Quick Measurement
Select [Quick measurement] icon on the main menu,
the system will enter the [Quick measurement]
interface. This interface provides an operating platform
for quick measurement, which can test and display
toe-in and camber of front and rear wheels at the same
time. The interface is as shown in the following figure:
Fig.4.32
[Select Vehicle Model]: You can select the parameters of
standard vehicle models to be convenient for vehicle
adjustment (Please refer to [Standard
Measurement]-[Select Vehicle Model]);
[Print Report]: To provide the functions for saving and
printing the test data (Please refer to [Standard
Measurement]-[Print Report]).
[Figure Format]: It is the data display interface which can
be switched to Figure Format. The fig-format data
display interface provides the display for thrust angle.
The interface is as shown in Fig.4.33.
Fig.4.33
Note:
Print
Save
Vehicle license
To Next Page
Loading...
