Need help?Do you have a question about the LDS Dactron PHOTON II and is the answer not in the manual?
General| Brand | LDS |
|---|---|
| Model | Dactron PHOTON II |
| Category | Measuring Instruments |
| Language | English |
Outlines general safety precautions for operating, maintaining, and calibrating the system.
Lists critical warnings regarding system operation, voltage hazards, and environmental exposure.
Guides users through installing the necessary Windows driver for the Photon II.
Explains the purpose and scope of calibration, focusing on offset and gain error.
Outlines the major steps involved in the calibration process.
Details the process for calibrating the output channel, including DC offset.
Describes validating calibration results by re-measuring DC offset and RMS values.
Addresses errors when the Photon II is not connected via USB before starting the software.
Guides on verifying the correct installation of the USB device driver.
Discusses issues with initializing the Photon II, possibly due to power or connection.
Covers error messages and recovery when the USB cable is disconnected during operation.
Identifies signs of insufficient USB power supply from the PC or hub.
To Next Page
