156 Service & Repair
Electrical System
The packer electrical system includes all of the body running and marker lights, operational speed up
switches, the operator ready and back-up warning alarms, and all interconnected wiring.
Testing
To locate a defective component or break in the wiring, perform a continuity check across the
between suspected components (see Electrical Testing on page 37).
Repair
Repair of the electrical system is limited to the replacement of burned-out bulbs and other defective
parts or wiring.
Inspection
Operate all light switches and push-button controls to insure that they are operating normally.
Check all wiring for breaks, frayed or worn insulation and loose terminal connections.
Schematics
Electrical and hydraulic schematics may be viewed or downloaded from Labrie Parts and Service
website.
Service Tools
The Service Tools shown in this section will be required for some service and repair procedures.
These tools are available from your local authorized Labrie Enviroquip Group Distributor.
1
2
3
4
To Next Page
Loading...