Leach 2R-III - Prior to Start-Up

30 Safety
Figure 2-16 Drain valve on air tank
Prior to Start-Up
Before starting the vehicle:
1. Make sure no system will engage and/or start to operate as you start the engine.
2. Make sure the shut-off valve on the hydraulic tank is fully open before starting the vehicle
(see Figure 2-17).
Figure 2-17 Suction line shut-off valve
NOTE: The hydraulic tank model may vary according to the options installed on the vehicle.
3. Engage the hydraulic system by switching on the Pump ON/OFF switch on the cab dashboard or
on the console (see Figure 2-18).
Warning!
Failure to fully open the main valve will cause immediate damage to the pump, even if
the pump is turned off.