BT/S Variable-Speed Peristaltic Pump
Note 1. Time Unit: Time unit for dispense mode. The time can be in
hours, minutes or seconds.
Note 2. DispTime: Dispense time for Time Dispense mode. It is the
dispense duration for each dose. The range is 0.1-999
seconds/minutes/hours.
Note 3. Pause Time: Pause time for dispense mode. It is the lag time
between doses when the number of cycles setting is more than 1. The
range is 0.1-999 seconds/minutes/hours.
Note 4.Cycles: Number of cycles for dispense mode. The range is
0-999 cycles. When it is set to 0, the dispense process will keep running
until START/STOP is pressed. When it is set to the other value, pump
will stop when pump finishes dispensing the set number of cycles
(
Figure 20).
Note 5.Reverse Angle: To minimize the drip after a dispense, the drive
can reverse direction to draw the fluid back at the end of the tubing. The
reverse angle range is 0-720 degrees. When it set to 0, the anti-drip
function is disabled.
Note 6. Max Speed: Maximum speed for External Control mode. It is
the maximum speed that the external analog signal can control.
Note 7. Pump No: It is the pump communication address for
communication mode. When the number is changed, please restart
pump to apply the setting.
Note 8. Beep Setting: Set the key tone on or off.
Note 9. Language: System language setting, English or Chinese.
Note 10. Contrast: LCD backlight contrast setting.
9 Tel：0312-3250677 3250877 3250977 Fax：0312-3250877-804
To Next Page
Loading...
