BT/S Variable-Speed Peristaltic Pump
START/STOP key will work. On the main screen, press and hold the
DIRECTION key to lock the keypad; press and hold the START/STOP key
to unlock the keypad.
Keypad unlocked Keypad locked
Figure 7. Keypad Lock
4.2.6 F. Communication State
It shows the current RS485 communication state.
#1
disconnected
number is set to 1
Figure 8. Communication state
4.2.7 G. Rotating Speed State
It shows the current rotating speed, rpm. When the drive is running at full
speed, the display will be >>>>>>>.
5 Parameter Settings
On the main screen, press the MENU key to enter the setting menu, and
press UP or DOWN key change the value, then press MENU key again to
confirm the setting. The screen will change to the setting for next parameter.
To return the main screen, press and hold the MENU key or press the
MENU key a few times until it goes back to the main screen (
Figure
9).Please note for Time Dispense mode, there are 5 parameters; for the
other modes, there are 6 parameters.
7 Tel：0312-3250677 3250877 3250977 Fax：0312-3250877-804
To Next Page
Loading...
