Calculate the ratio to 10 MHz for each channel, sdev
2000.1/ sdev10 (for
WaveRunner 6200)
, sdev1000.1/ sdev10 (for WaveRunner 6100), sdev500.1/sdev 10
(for WaveRunner 6050 or 6051), sdev350.1/ sdev10 (for WaveRunner 6030) and
compare the results to the limits in the test record.
Repeat the above steps for V/div setting of 50 mV, 100 mV, and 500mV, using
the appropriate Bandwidth - CHx yymv.lss (where x is channel and yy is V/div
setting) panel setup and recording your results in Tables 14 through 16. Use the
power setting and attenuators as shown in the tables.
WR6K Rev.D Performance Verification 5-35
To Next Page
Loading...
